Differences

This shows you the differences between two versions of the page.

--- nimrod_2022 [2022/09/14 08:01] – simonw7
+++ nimrod_2022 [2022/09/14 08:29] (current) – simonw7
@@ Line 74: / Line 74: @@
 After this has been done, run the config scripts from the corresponding directory and then use the make install command. This should successfully make the serial and parallel versions of nimdevel.
-====   Modifying and recompiling the code  ====
-One method of easily modifying the code one NERSC is to use Juypter notebook. Further instructions can be found here:  https://docs.nersc.gov/services/jupyter/ \\
-If the source code is modified, the user does not need to repeat all of the steps listed above for compiling the code. Instead the user can move to the build directory and use the make/make install command again. This will save time instead of rebuilding the entire code again.
 ===== Compiling older versions at NERSC =====
@@ Line 91: / Line 86: @@
   set(CMAKE_Fortran_FLAGS "-fallow-argument-mismatch ${CMAKE_Fortran_FLAGS}")
+=====   Modifying and recompiling the code  =====
+One method of easily modifying the code one NERSC is to use Juypter notebook. Further instructions can be found here:  https://docs.nersc.gov/services/jupyter/ \\
+If the source code is modified, the user does not need to repeat all of the steps listed above for compiling the code. Instead the user can move to the build directory and use the make/make install command again. This will save time instead of rebuilding the entire code again.